PRODUCT FEATURES
- Great for ceramic and porcelain tiles installation with a maximum size of 60×60 cm.
- High water resistance and bonding strength.
- Well applied both residential and commercial projects.
- Suitable for interior use on floors and walls.
- Color : Grey
APPLICATION INSTRUCTION
Substrate preparation
All surfaces on which tile is to be set must be dry, structurally sound, free of all grease, oil, dirt, dust, curing compounds, sealers, coating, efflorescence, old adhesive residues, gypsum based underlayment and any other foreign matter.
Proportion of mixing
Dingo Tile Bond Tile Adhesive 25 kg (per bag) per 5.3-5.7 L of water or 4.5 parts of Dingo Tile Bond Tile Adhesive per 1 part water by volume.
Mixing
- Mix Tile Adhesive with clean, potable water thoroughly until smooth with a mechanical mixer at a low speed 150 rpm).
- Let mortar slakes for 5 minutes before mixing a second time.
- Do not add water, latex, or additional powder after slaking period.
Application
- Choose a typical notched trowel that is suitable with each type of tiles. Use flat side of the trowel, applying a film layer of tile adhesive into surface. Apply additional tile adhesive, sweep the surface with notched side of the trowel, held at 60 degrees to create the optimal texture in a single direction.
- Place the tiles into the surface, push the tiles back and forth in a perpendicular direction with trowel lines to help achieve maximum coverage and arrange the tiles in place.
- Use a rubber hammer to tap lightly on the tiles surface to ensure that the tiles have completely adhered to the tile adhesive.
- Remove excess tile adhesive from the joint areas to grouting.
- Do not adjust tiles in mortar after they have been set for longer than 15 minutes.
Curing and grouting
- A minimum cure is obtained in 24-48 hours, depending on ambient temperatures.
- For better quality, Dingo Grout should be chosen to suit each type of tiles. Dingo Grout has many types and color for each joints and places.
TECHNICAL DATA
| Test | Requirement | Test result |
| Adhesion Strength in standard condition | ≥ 0.5 N/mm2 | Pass |
| Adhesion Strength after water immersion | ≥ 0.5 N/mm2 | Pass |
| Open time | ≥ 20 phút | Pass |
| Slip | ≤ 0.5 mm | Pass |
Choose notched trowel and conpsumtion
| Size of trowel | Size of tile | Approximate area (per bag 25kg) |
| 3×3 mm | For mosaic and tiles from 2×2 cm to 5×5 cm |
9-10 m2 |
| 6×6 mm | For tiles from 10×10 cm to smaller 30×30 cm | 6-8 m2 |
| 10×10 mm | For tiles, stone > 40×40 cm | 2.5-4 m2 |
Suggestion
Grouting after tile installation at least 24 hours to achieve maximum efficiency.
Limitations
Do not use tile adhesive with wood, asphalt, plastic coat or PVC, metal and mirror.
Caution
- Cement may cause injury to skin or eyes.
- Use of rubber gloves, dust masks, eye protection, and other safety equipment is recommended.
- If contact with eyes occurs, flush immediately and repeatedly with water, and then contact doctor immediately.
- Avoid contact with skin. Wash thoroughly after handling.
- Keep out of reach of children
Storage
It should be kept in a dry place and the temperature is not too high to avoid product’s degradation. Age of product is 1 year.
Packing
Net weight: 25 kg
Reviews
There are no reviews yet.